|
technical tips
directions for usage
- Clean the surfaces properly
- Apply thin coats on the both surfaces
- Apply brush only in unidirectional manner
- Wait for about 5 to 10 minutes, until the adhesive is dry
- Press together the substrates
- Allow setting time under pressure for best results
handling and storage
It is important to note some precautions in handling and storage.
- Place the container box upright always during storage.
- It is advised that the products be stored at room temperature (16 - 30 Deg C). By not doing so, variation in physical and chemical properties is likely to occur. The area must be provided with adequate ventilation and kept clean, dry and free of heat and ozone generating equipment.
- The container should only be opened when required and kept closed at all other times.
|
 |
 |
Rubfila's fully-equipped chemical laboratory uses sophisticated ... more |
|
